Previous Up Next
The Ray Allen trim servo gets mounted on the E-616PP trim cover plate on the two EET-602B channel servo supports (actually EET-602B-R and EET-602B-L)
You install it with the little screws that come with it.
I've just riveted all of the plate nuts to the E-615PP trim access reinforcement plate. 
I cut the threaded rod that came with the servo just about in half.
and I installed it on to the servo with the clevis and pin.
Screw the access plate in to place.
Attach the other end of the threaded rod to the trim tab horns and you're good to go.